Controller for Niko Home Control

This is the central regulating unit of the system. One controller is needed per installation to program the system. You can check the functioning and the status of the modules with one push of the test button. Using the programming button, you program the basic functions, such as lighting and roller blind control, without having to use a PC. All of the settings are saved in this module. The controller is delivered with an installation and a user manual.

This article is protected by at least one patent (application). For more info on patents, see www.niko.eu/innovation.

Controller for Niko Home Control.

• Function: The controller operates the Niko Home Control installation based on the pre-programmed settings stored in the system (internal memory chip).

One controller is required per installation. A second controller may be used to operate as a back-up.

Only the POWER LED of the power supply module and the ETHERNET LED of the IP module will be lit when the Niko Home Control installation is functioning properly. The remaining LEDs are not lit, to help save energy.

When the module is functioning properly, the STATUS LED will light up in TEST mode only. If one or several errors occur, the LED will blink to indicate the error code of the error with the highest priority.

A number of basic functions can be temporarily programmed manually. This allows you to test the lighting options or operate the roll-down shutters during the construction of your dwelling. Product in accordance with over-voltage category III and pollution degree II.

• Sliding contact to connect the module to the following module on the DIN rail
• One RJ45-port for programming using the PC via TCP/IP
• Button for manual programming
• DIN dimensions: 2U
• Marking: CE