Nikobus base for motion detector 180°

Nikobus base for motion detector 180°. This Nikobus interface actuator translates the switching command originating from the connected sensor into a Nikobus telegram and transmits it over the bus. Equipped with two external inputs for push buttons or switches. Only for indoor use in combination with a Niko sensor: XXX-78200

Nikobus base for motion detector 180°.

• Function: This Nikobus interface actuator translates the switching command originating from the connected sensor into a Nikobus telegram and transmits it over the bus. Equipped with two external inputs for push buttons or switches. Only for indoor use in combination with a Niko sensor: xxx-78200. The actuator requires flush-mounting. Minimum depth flush-mounting box: 40 mm. Power supply: 12V~ or 14Vdc. Ambient temperature: during storage and transport: min. -25°C / max. +70°C; under operation: min. 0°C / max. 40°C. 4 connection terminals.
• Protection degree: IP41 for the combination of a mechanism, central plate and faceplate
• Flush-mounting frame
  • 1 mm-thick metal
  • galvanized on all sides after cutting, even on the cut edges
  • with 4 grooves with screw hole of 7 mm
  • with 4 screw holes (indicated by a screw symbol) with a diameter of 3 mm for mounting on panels
• Fixing method
  • with screws for simple fixing in a flush-mounting box with grip surfaces
• Centre-to-centre distance
  • Simple and quick assembly of one or more mechanisms by the indication (chalk line, laser, etc.) of the centre of the flush-mounting frame
  • vertical coupling centre-to-centre distance 60 mm by sliding several bases into each other, they lock themselves automatically
  • vertical coupling centre-to-centre distance 71 mm using pre-formed lips at the bottom, by folding the lips downwards over a length of 1 mm, the bases support each other and the centre-to-centre distance is guaranteed.
  • horizontal connection of multiple bases is quick and perfect thanks to the folded-up dovetails on the left and right sides
  • extra robustness due to the folded-up edges on the outside of the base and the continuation into the inside of the base
• End border: The flush-mounting frame is equipped, both on the top and the bottom, with a dark grey, plastic end border. This border is made of PC+ASA and is joined to the flush-mounting frame using a melting process. The corners of the two end borders are equipped with rectangular openings (7.9 x 1.5 mm) each containing a multi-positional snap hook. Thanks to the snap hooks, the 4 rectangular openings ensure that the faceplate can always be attached flat to the wall, even in cases of untidy plasterwork. This works in two directions: If the flush-mounting box sticks out of the plasterwork, the multi-positional snap hooks can compensate for a 1 to 1.2 mm margin; if the flush-mounting box is sunk too deeply in the plasterwork, the snap hooks can compensate for up to a 1.8 mm margin. The end borders also have 4 round openings that ensure the correct positioning of the faceplate in relation to the central plate.
• Wire connection
  • each connector block is equipped with cage clamps with permanent screws with a slotted screwhead (slot 1 x 4.5 mm)
  • every screw is provided with a screwdriver slot that prevents the screwdriver from sliding off the screwhead.
• Wire capacity
  • 2 x 1.5 mm² or 1 x 2.5 mm² per connection terminal
• Dimensions (HxWxD): 71 x 73 mm
• Marking: CE