RF receiver, potential free, 1 changeover contact, flush mounting

This flush-mounted receiver allows switching an electrical device ON and OFF using a wireless Easywave button or a wired button. This receiver has a potential-free changeover relay contact, suitable to control devices such as a doorbell or a dimmer.

It can receive signals from a Niko Easywave hand-held transmitter and/or wireless switch. The receiver can be installed behind a Niko blind plate or push button in the colour of your choice. Please note that the combination with the push button requires a wall mounting box with an installation depth of minimum 50 mm.

Up to 32 transmission codes can be programmed into the receiver. The receiver is equipped with either 1-button operation (ON/OFF, DEAD MAN, TIMER) or 2-button operation (ON/OFF, LOGIC).

RF receiver, potential free, 1 changeover contact, flush mounting

• Radiated power: 6.38 mW
• Modulation: FSK
• Input: 1 external push button
• Output: 1 potential-free relay contact (changeover)
• Power consumption (stand-by): 0.3 W
• Power consumption without load: 0.8 W
• Maximum contact load:

- resistive load cosφ=1: 10 A / 2300 VA (N.O.), 6 A / 1380 VA (N.C.)

- inductive load cosφ=0.8: 3 A / 690 VA (N.O.), 2 A / 460 VA (N.C.)

• Not compatible with Niko Home Control (wireless bridge or wireless smart hub)
• Input voltage: 230 Vac ± 10 %, 50 Hz
• Maximum MCB rating: 10 A (limited by national installation rules)
• Communication protocol: Easywave
• Operating frequency: 0.8683 GHz
• Ambient temperature: -20 – +45 °C
• Protection degree: IP20
• Weight: 31 g
• Wire capacity: – 1 x 2.5 mm² per connection terminal
• Marking: CE