Base for universal push-button dimmer 450 VA, 2 wire

Base for a universal push-button dimmer with a capacity of 450 VA. A finishing set XXX-31001 in the colour of your choice should be ordered separately.

Base for universal push-button dimmer 450 VA, 2 wire.

• Function: The flush-mounting dimmer automatically selects leading edge or trailing edge. For resistive, capacitive and inductive loads. Practically completely silent thanks to the advanced transistor technology. Maximum 30 control points with N.O. push buttons in parallel. Interference suppression of the push button input. Connection of the push buttons in various configurations is possible. A brief press of the button switches the light on or off. A longer press controls the dimmer. Pressing again reverses the dimming direction. Can be used in single-pole, two-way or intermediate circuits. Use with or without memory can be set using the push button input. Non-volatile memory. The degree of interference suppression complies with the European standard EN 55015. For use with or without light value memory
• Minimum load: 40 W/40 VA
• Maximum load electronic transformer: 450 VA
• Maximum load ferromagnetic transformer: 450 VA
• Maximum load toroidal core transformer: 450 VA
• Hum-free: yes
• PLC interference suppression: this dimmer is equipped with interference suppression of PLC signals (frequency dips up to 3 Hz). This integrated interference suppression attempts to remove as many interfering signals as possible from the mains in order for most lamps to function optimally, without flashing or humming.
• Protection from overload: thermal overload protection with automatic reset function
• Short circuit proof: electronic short-circuit protection
• Capacity reduction: at an ambient temperature above 20°C the maximum load will decrease by 5 % per 5 °C
• Flush-mounting frame
  • 1 mm-thick metal
  • galvanized on all sides after cutting, even on the cut edges
  • with 4 grooves with screw hole of 7 mm
  • with 4 screw holes (indicated by a screw symbol) with a diameter of 3 mm for mounting on panels
• Fixing method
  • with screws for simple fixing in a flush-mounting box with grip surfaces
• Wire connection
  • the sockets are equipped with screw terminals for clamping the wires.
• Wire capacity
  • 2 x 1.5 mm² or 1 x 2.5 mm² per connection terminal
• Centre-to-centre distance
  • Simple and quick assembly of one or more mechanisms by the indication (chalk line, laser, etc.) of the centre of the flush-mounting frame
  • vertical coupling centre-to-centre distance 60 mm by sliding several bases into each other, they lock themselves automatically
  • vertical coupling centre-to-centre distance 71 mm using pre-formed lips at the bottom, by folding the lips downwards over a length of 1 mm, the bases support each other and the centre-to-centre distance is guaranteed.
  • horizontal connection of multiple bases is quick and perfect thanks to the folded-up dovetails on the left and right sides
  • extra robustness due to the folded-up edges on the outside of the base and the continuation into the inside of the base
• End border: 4 rectangular openings (7 x 2.5 mm) which, if the flush-mounting box protrudes from the plasterwork, can compensate for a margin of between 1 and 1.2 mm, so that the faceplate can still butt up perfectly against the wall
• Input voltage: 230 Vac ± 10 %, 50 Hz
• Connection terminals: 3 connection terminals
• Dimensions (HxWxD): 71 x 73 mm
• Marking: CE