Base for rotary dimmer, 320 VA, 2 wire

Base for a rotary dimmer with a capacity of 320 VA. A finishing set XXX-31000 and faceplate in the colour of your choice must be ordered separately.

Base for rotary dimmer, 320 VA, 2 wire.

• Function: Flush-mounting dimmer controlled via rotary button for capacitive and resistive loads. Trailing edge for resistive and capacitive loads (adjustable electronic transformers). Filter for preventing instability caused by the central remote control system. Activate by pressing on the button and adjust by rotating the knob. Can be used in single-pole, two-way or intermediate circuits but can only replace a single or two-way switch (built-in two-way switch). The degree of interference suppression complies with the European standard EN 55015.
• Minimum load: 20 W/35 VA
• Maximum load electronic transformer: 320 VA
• Hum-free: yes
• PLC interference suppression: this dimmer is equipped with interference suppression of PLC signals (frequency dips up to 3 Hz). This integrated interference suppression attempts to remove as many interfering signals as possible from the mains in order for most lamps to function optimally, without flashing or humming.
• Protection from overload: thermal overload protection. Protection against repetitive overload. Automatic reset function of the protections.
• Short circuit proof: electronic short-circuit protection
• Capacity reduction: at an ambient temperature above 20°C the maximum load will decrease by 5 % per 5 °C
• Flush-mounting frame
  • 1 mm-thick metal
  • galvanized on all sides after cutting, even on the cut edges
  • with 4 grooves with screw hole of 7 mm
  • with 4 screw holes (indicated by a screw symbol) with a diameter of 3 mm for mounting on panels
• Fixing method
  • with screws for simple fixing in a flush-mounting box with grip surfaces
• Wire connection
  • the sockets are equipped with screw terminals for clamping the wires.
• Wire capacity
  • 2 x 1.5 mm² or 1 x 2.5 mm² per connection terminal
• Centre-to-centre distance
  • Simple and quick assembly of one or more mechanisms by the indication (chalk line, laser, etc.) of the centre of the flush-mounting frame
  • vertical coupling centre-to-centre distance 60 mm by sliding several bases into each other, they lock themselves automatically
  • vertical coupling centre-to-centre distance 71 mm using pre-formed lips at the bottom, by folding the lips downwards over a length of 1 mm, the bases support each other and the centre-to-centre distance is guaranteed.
  • horizontal connection of multiple bases is quick and perfect thanks to the folded-up dovetails on the left and right sides
  • extra robustness due to the folded-up edges on the outside of the base and the continuation into the inside of the base
• End border: 4 rectangular openings (7 x 2.5 mm) which, if the flush-mounting box protrudes from the plasterwork, can compensate for a margin of between 1 and 1.2 mm, so that the faceplate can still butt up perfectly against the wall
• Input voltage: 230 Vac ± 10 %, 50 Hz
• Connection terminals: 3 connection terminals
• Dimensions (HxWxD): 71 x 73 mm
• Marking: CE